GNS 430(A) Pilot’s Guide and Reference
190-00140-00 Rev. P
APPENDIX A
DATA CARD USE
A-1
APPENDIX A: DATA CARD USE
The Jeppesen NavData Card, and the Terrain Data
Card (if applicable) supplied with the GNS 430 can be
installed or removed when the GNS 430 is on or off. If the
NavData Card is not present when the unit is turned on, a
‘No Jeppesen Aviation Database - Limited to user defined
waypoints’ message appears on the
Database Confirmation
Page. If the NavData Card is removed during operation,
a ‘Data card removed - Unit will restart in 30 seconds’
warning is displayed. A counter begins to count down
and, if the card is not replaced within 30 seconds, the
GNS 430 automatically re-initializes. Pressing the
ENT
Key will manually re-initialize the unit.
Figure A-1 Data Card Slot Locations
Terrain Data
Card Slot
(right-hand slot)
NavData
Card Slot
(left-hand slot)
To insert the NavData or Terrain Data Card
(Figure A-2):
1) Place the card into the appropriate card slot,
with the label facing to the left and the swing
arm handle at the bottom front.
2) Press the data card into place until it seats on
the internal connector and the front of the card
is flush with the face of the GNS 430 unit.
3) If the swing arm handle is up, gently lower the
handle and push it into place—flush with the
face of the GNS 430 unit.
Figure A-2 Data Card Insertion/Removal Detail
Summary of Contents for GNS 430
Page 1: ...GNS 430 A Pilot s Guide and Reference ...
Page 2: ......
Page 116: ...GNS 430 A Pilot s Guide and Reference 190 00140 00 Rev P SECTION 6 PROCEDURES 6 34 Blank Page ...
Page 265: ......