Garmin CR 1522, Owner'S Manual

Page: 15 / 74

1.4 Installation 13
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
•
Marine sealant (recommended)
1.4.3 Mounting Considerations
NOTICE
This device should be mounted in a location that is not exposed to extreme
temperatures or conditions. The temperature range for this device is listed in the product
specifications. Extended exposure to temperatures exceeding the specified temperature
range, in storage or operating conditions, may cause device failure. Extreme-
temperature-induced damage and related consequences are not covered by the warranty.
When selecting a mounting location, you should observe these considerations:
• The location should be directly in front or slightly to your left as you operate your boat,
to provide optimal viewing and allow easy access to all device interfaces, such as the
control panel and the SD card slots.
• The location must be strong enough to support the weight of the device and protect it
from excessive vibration or shock.
• To avoid interference with a magnetic compass, the device should not be installed
closer to a compass than the compass-safe distance value listed in the product
specifications.
• The location must allow room for the routing and connection of all cables.
1.4.4 Bail Mounting the Device
NOTICE
If you are mounting the bracket on fiberglass with screws, it is recommended to use a
countersink bit to drill a clearance counterbore through only the top gel-coat layer. This
will help to avoid cracking in the gel-coat layer when the screws are tightened.
Stainless-steel screws may bind when screwed into fiberglass and overtightened. It is
recommended to apply an anti-seize lubricant on the screws before installing them.
You can use the bail mount bracket to bail mount the device on a flat surface.
1 Using the bail mount bracket as a template, mark the pilot holes.