Garmin 500W Series, Pilot'S Manual & Reference, Page: 200 / 236

9 - AUX PAGES
190 190-00357-00 Rev G
Setup 1 Page
display traffic information. This allows you
to monitor traffic conditions from ANY page
and quickly identify traffic hazards. See the
400W/500W Series Display Interfaces Pilot's
Guide Addendum for more information on
traffic data.
3. Press ENT to accept the selection.
4. If “Configurable Data Fields” is selected, a
second selection field appears to allow you
to select the desired data type. Turn the
large
right knob to highlight this second field, then
turn the small right knob to display a list
of available navigation data types. Continue
turning the
small right
knob to select the
desired data type and press ENT to approve
your selection.
COM Configuration
To set the COM channel spacing:
1. Select “COM Configuration” from the Setup 1
Page.
2. The flashing cursor highlights the channel spac-
ing field. Turn the small right knob to select
the desired channel spacing: 8.33 kHz or 25.0
kHz. Press
ENT
when finished.
8.33 kHz and 25.0 kHz channel spacing are
available for the GNS 530W’s COM trans-
ceiver. Use the 25.0 kHz setting in the United
States.
Preset Com Frequencies
On units configured for COM Frequency Presets
you may store up to 15 preset Com frequencies in the
Com Configuration page. On units configured with a
remote Com frequency recall switch, these preset fre-
quencies can be loaded into the STBY frequency with
the press of a button.
NOTE
: Preset Com Frequencies are only available with
Main System Software Version 3.00, or later.
To store a preset Com frequency:
1. Select “COM Configuration” from the Setup 1
Page.
2. The flashing cursor will highlight the Channel
Spacing field. Turn the large right knob to
highlight the left (non-decimal) part of the first
frequency field.