![background image](http://html1.mh-extra.com/html/garland/xg36/xg36_installation-and-operation-manual_3768848016.webp)
Part # 4517124 Rev. 7 (08/17/11)
Page 16
CLEANING AND MAINTENANCE
continued
PLATEN ZEROING
Turn Master power switch “ON”, wait for controllers to display
“OFF”.
Note: Release sheets should not be installed during this
procedure.
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5. Press eight, (8) times. “PLATEN SET +/- XX” is displayed.
(XX=numbers that will vary from grill to grill.)
6. Allow time for grill to heat and turn ready. Press
both the Cancel (Green) and Standby (Black) buttons
simultaneously to lower the upper platen. Press the
•
Rinse the edges of all three
platens.
• Press green button to raise
center platen.
•
Pour a small amount of
lukewarm water on a
clean, sanitizer-soaked
grill cloth over the
bottom grill surface and
wipe off residue.
•
Place upper platen
release material sheets
fl at on the lower grill
surface.
• Gently clean both sides
of the release material
sheets with the grill
cleaning pad
•
Rinse both sides of
the release material
sheets with a clean,
sanitizersoaked grill cloth.
• Reinstall the release
material sheets. Secure in
place with bars and clips
13
14
15
16
17
18
19
20
•
Wipe lower grill with a
clean,sanitizer-soaked
grill cloth. Repeat until no
visible soil remains.
•
Empty, wash, rinse,
and replace the grease
troughs.
•
Wipe remaining grill
surfaces with a clean,
sanitizer-soaked grill
cloth.
•
Apply a thin coat of fresh
shortening to the lower
grill surface only..
Summary of Contents for XG36
