Garland SET 802 G, Instruction Manual

Page: 37 / 144

English
36/144
English
37/144
tank. In case of petrol leakages, eliminate these before
starting the machine. do not attempt to start the
engine but move the machine away from the area of
spillage and avoid creating any source of ignition until
petrol vapours have dissipated.
Stay away at least 3 meters from the zone where you
have refuelled before started the machine.
Refill fuel before to start the machine. Do not remove
the petrol cap whilst the engine is running or engine
is hot.
Do not use fuel with ethanol or methanol because will
damage the engine.
6.4. START UP
6.4.1. CHECKING POINTS PRIOR TO USING THE
MACHINE
Do not use the machine if it is damaged or not
well regulated.
Use this machine to do jobs for which it has been
designed. Any other use could be dangerous to the
end user, for the machine and to other people, animals
and things that are nearby.
Verify that :
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- Ensure that the protector is well fixed to the
machine.
- There are not fuel leaks.
- Check the air filter is clean. Clean the filter if
necessary.
Press, repair or replace everything you need before
using the machine.
Tighten, repair or replace parts that you find to be in
a bad state.
Do not use attachments on this machine out of our
recommendations because their use may cause
serious injury to the user, the machine and the people,
animals and things close to the machine.
Before start up, remove the security blade protector
from the blade.
Before start up, ensure that all moving parts are not in
contact with any object.
6.4.2. START UP
Follow the instructions of cold or hot start up
depending on the state of the machine.
6.4.2.1. START UP IN COLD
Place the machine on a flat, stable surface to start it.
Place the switch in the ¨I¨
position.
Press the primer bulb several times (7 to 10 times)
until the fuel reaches the carburetor.
Put the air lever in the close position .
Hold the machine firmly in place by the handle so that
when you pull the starting rope the machine does not
move.
I
ST0P