Garland PASTA MAGIC, Installation And Operation Manual

Page: 20 / 24

Document # G_GHD_OM_PASTACUISINE_4607873 – 08/21 20
OPERATOR TROUBLESHOOTING Continued
Problem Probable Causes Corrective Action
ON UNIT WITH AUTOFILL, WATER DID
NOT SHUT OFF WHEN COOKPOT WAS
FULL
A. Dirty water level sensors. A. A. Remove the probe block
cover and clean the sensors using
a Scotchbrite™ or similar pad and
a solution of detergent and water.
NOTE : Do not use deliming solution.
B. Insufficient mineral content in water. B. B. Add 1/8-cup of baking soda
to the water in the cookpot as the
unit fills.
DO NOT USE SALT
! Doing
so will damage the cookpot. Avoid
using distilled, highly filtered, or
deionized water.
C. Failed upper water level sensor,
loose or broken upper water level
sensor wiring, failed water solenoid
valve.
C. Call FASC.
AUTOSKIM DOES NOT WORK
(AUTOFILL functions correctly.)
A. Failed controller. (If the AUTOFILL
functions correctly, the only cause
possible is a failed controller.)
A. Order replacement controller from
FASC or distributor.
WATER WILL NOT BOIL
(Cookpot verified to be full of water
with Boil Mode selected, i.e., left
indicator is lit and burners are lit.)
A. Failed controller. A. Order replacement controller from
FASC or distributor.
WATER BOILS IN SIMMER MODE
A. Controller out of adjustment. A. Adjust controller in accordance with
procedure in Chapter 4.
B. Failed controller. B. Order replacement controller from
FASC or distributor.
B. Failed/shorted temperature probe. C. Call FASC.
WATER TEMPERATURE IS TOO LOW IN
SIMMER MODE
A. Controller out of adjustment. A. Adjust controller in accordance with
procedure in Chapter 4.
B. Failed controller. B. Order replacement controller from
FASC or distributor.
C. Open temperature probe or loose
probe wire.
C. Call FASC.
BASKET LIFT MOVEMENT IS JERKY OR
NOISY
A. Lack of lubrication on basket lift
rods.
A. Lubricate lifter rods with a
lightweight lubricant.