INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
PART #4527466 (12 Aug 2011)
Page 56
TO REPLACE THE SHAFT SEALS
(continued)
TO REPLACE THE SHAFT SEALS & CAP O-RINGS
4. Lift up the seal cap through shaft and re-
place old shaft seal by the new split shaft
seal.
5. Remove old screw o-rings and replace by
new o-rings. Reinstall seal cap in place and
slightly tighten screws DO NOT OVER-TIGHT.
Turn main power switch on, the platen will
lower, press green button to raised and low-
ered the platen a couple times. Final step
tighten the seal cap screws down fi rm in
place.
1. It is recommended
that the platen be
in the down posi-
tion when replac-
ing the shaft seals.
With the control
in the OFF mode,
Press the GREEN
push button to
lower platen.
2. Remove carriage
block locking key
from carriage
block using a 7/16”
wrench or socket
to unscrew two
screws. The lock-
ing key will allow
the platen arms
to separate from
the shafts without
having to remove
the entire shaft as-
sembly.
Summary of Contents for MWE2W
Page 2: ......