![background image](http://html1.mh-extra.com/html/garland/master-xpress-xe241l/master-xpress-xe241l_installation-operation-and-maintenance-manual_3739318016.webp)
Part # 4517125 Rev. 3 (18 May 16)
Page 16
PLATEN ZEROING
Turn Master power switch “ON”, wait for controllers to display
“OFF”.
Note: Release sheets should not be installed during this
procedure.
1. Press and hold
for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5. Press
eight, (8) times. “PLATEN SET +/- XX” is displayed.
(XX=numbers that will vary from grill to grill.)
6. Allow time for grill to heat and turn ready. Press
both the Cancel (Green) and Standby (Black) buttons
simultaneously to lower the upper platen. Press the
Cancel (Green) button to raise the platen. Now, press both
the Cancel (Green) and (Black) Buttons to re-lower the
platen.
7. Remove platen adjuster caps from all four adjustment
points on each platen. Remove the four locking caps from
the adjustment points.
8. Using the adjusting tool lower platen until adjusting tool
touches the arm assembly.
9. With gapping tool, adjust right rear of platen until the
gapping tool fi ts snugly between the upper platen and
grill surface.
10. Move next to the left front adjuster and raise the platen
until the gapping tool fi ts snugly between the upper
platen and grill surface.
11. Next go to the left rear adjuster and raise the platen until
the gapping tool fi ts snugly between the upper platen
and grill surface.
12. Move next to the right front adjustment and raise the
platen until the gapping tool fi ts snugly between the
upper platen and grill surface.
13. Repeat steps 9-12 one or more times until gapping tool
fi ts snugly between the upper platen and grill surface at
all four adjustment points without further adjustment.
(See diagram below.)
14. Replace the platen adjuster locking caps “hollow side
down” and tighten snugly. Replace platen adjuster caps.
15. Repeat steps 9-14 for each platen.