![background image](http://html1.mh-extra.com/html/gardner-denver/welch-vcpro-600-series/welch-vcpro-600-series_operation-manual_563862025.webp)
Assembly and installation
Operation manual VCpro 600
25
5
Assembly and installation
5.1
Unpacking
Unpack the device carefully.
Check for:
Transport damage,
Matching with the specifications of the delivery contract and
Completeness of the delivery.
Inform us immediately if there are differences from the contractually agreed-upon scope of
delivery or damage!
Heed the manufacturer's General Terms and Conditions.
ATTENTION
►
Keep the packaging to send the vacuum controller back to the
manufacturer's factory or an authorized workshop for repair.
5.2
Set-up and connection
Depending on the device models, the device must be installed according to the identification
affixed to it,
see Chapter 4.4
Heed the appropriate safety instructions.
When setting up the vacuum controller, make sure that the distance to adjacent surfaces
is at least 5 cm. At the same time, ensure that there is sufficient ventilation.
Use only pre-assembled lines from the manufacturer, which prevents incorrect connec-
tions.
Check the vacuum lines and vacuum connections of the entire system for any leakage
before beginning work.
5.3
Electrical connection
The electrical connection is made with device connection cables with protective insulation.
DANGER
►
Caution, there is danger to life due to electrical energy when opening
the device.
►
If the user changes the electrical connection, e.g. for installation in a
system, this may only be done by a trained electrician adhering to the
accident prevention regulations.
►
Before opening the device, disconnect the power plug!
ATTENTION
►
By opening the device, the printed circuit board and display can be
destroyed by electrostatic discharge.