13-9-653 Page 5
Connection failure -
The controller checks input connectors and will shutdown if they become unplugged.
Other shutdowns -
The controller runs continuous diagnostic checks of its own operation and the sensors to which it
is connected. Refer to the service section for a complete listing of shutdowns and remedial actions.
PROGRAMMING AND SETUP FOR THE "AUTO SENTRY
®
-ES+" CONTROLLER
Programming and setup is accomplished with the PROGRAM keys. See
figure 1-1.
In all steps, the [ENTER] key
enters the displayed value into memory and advances to the next programming function. The plus [+] and minus [-]
keys will increase and decrease displayed numeric values, or step through menu selections. During numeric
adjustments, the left [<] and right [>] arrow keys, move the cursor (flashing digit) to the position desired. Use the
[+] and [-] keys to change the number at the cursor. At any point in the programming and setup routine, the
[STOP/RESET] key can be pressed to exit the adjustment mode without altering the adjustment. In all steps of the
programming routine, the top line of the display will give a description of the parameter to be programmed, while the
bottom line shows the variable that may be altered or stored.
The following is a step by step guide to programming the controller. Remember, between each step, it is necessary
to press the [ENTER] key to store the new value and advance to the next step.
Figure 1-2 – FLOW CHART
302EAU1255-B
(Ref. Drawing)
Summary of Contents for AUTO SENTRY-ES+
