![background image](http://html1.mh-extra.com/html/gardner-denver/apex15-18a/apex15-18a_operating-and-service-manual_3575531022.webp)
13-25-607 Page 20
11.
Target Pressure -
This is the package discharge pressure that the controller maintains by
modulating the motor speed with the variable frequency drive. See "Operational Settings" menu in
Controller Operating and Service Manual.
Operation at excessive discharge air pressure can cause personal injury or
damage to equipment. Do not adjust the full discharge air pressure above the
maximum stamped on the unit nameplate.
12.
Operating Mode
- See "Operational Settings, Operating Mode" menu in Controller Operating and
Service Manual.
13.
Enclosure
- Check for damaged panels or doors. Check all screws and latches for tightness. Be
sure doors are closed and latched.
The compressor starts and stops automatically. Automatic restarting can
cause injury or death. Open, lockout and tag out main disconnect and any
other circuits before servicing the unit.
The enclosure doors must be closed and latched to keep the compressor
package from overheating when the compressor is running.
After an emergency stop, be sure that the pressure in the air/oil reservoir is less
than 5 psig. Wait one minute or more before restarting.
Summary of Contents for APEX15-18A
