2
1.0 SAFETY SYMBOL DEFINITIONS
The symbol below is used to call your attention to instructions
concerning your personal safety. Watch for these symbols.
They point out important safety precautions. They mean
“ATTENTION! Become alert. Your personal safety is
involved.”
Read the message that follows and be alert to the
possibility of personal injury or death.
Is serious but less inevitable. There is some probability
that death, severe bodily injury or major property
damage could result.
Is less serious but still demands attention. Indicates a
hazard which may result in minor injury or property
damage.
2.0 WARNINGS
This section contains information for your protection,
safety and quick reference. When using an electrical
appliance basic precautions should always be followed,
including the following.
Read all Instructions before using the B2555
Sidewinder
®
Bender.
Never operate this Bender in an explosive atmosphere.
Never operate the Bender in wet or damp locations.
DO NOT expose the Bender to rain.
Never use an extension cord longer than 100 feet.
Never alter this equipment, doing so will void this warranty.
Never wear loose clothing while operating the Bender.
Never stand on tool. Serious injury could occur if the tool
is tipped or if the bending shoe is unintentionally contacted.
Never leave tool running unattended. Turn power off.
Do not leave tool until it comes to a complete stop.
Never force tool. If bending shoe will not turn, STOP unit
and unplug before checking for any obstructions.
Always use 120 V AC, 20 AMP ground fault protected
receptacle for power supply.
Always inspect power cord before using Bender. Replace
damaged or worn cords.
Always wear approved safety glasses when the bender is
in operation.
Always disconnect the Bender before servicing or
changing shoes, attachments or supports, and when not
in use.
Always inspect the Bender before operating. Replace
any damaged, missing or worn parts.
Always use 12-gauge 20 AMP extension cords that have
three prong grounding type plugs and three-hole
receptacles that accept the Bender’s plug.
Always keep hands and feet away from pinch points
such as bending shoes, rollers and conduit when Bender
is in use.
Always keep conduit under control when bending.
Always keep the path of the bending conduit clear of
obstructions. Make sure all obstacles are clear of the
bending path BEFORE you bend the conduit.
Always use the appropriate shoe groove and roller
support for the type and size of conduit to be bent.
Always use the Bender in a dry, well lit area. Always
maintain Bender with care. Keep Bender clean for best
and safest performance.
Always make sure switch is in the off position
before plugging in. This will reduce the risk of
unintentional starting.
Always use recommended accessories. Consult this
manual for recommended accessories. The use of
improper accessories may cause risk of injury.
Always check for damaged or worn parts. Before further
use of the tool a guard or other part that is damaged
should be carefully checked to determined that it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any other
conditions that may affect its operation. A part that is
damaged should be properly repaired or replaced.
!
WARNING
WARNING
