Wiring Connections
Page
17
Page
16
Wiring Connections
Keypad Terminal Connections
Some keypads that are compatible with other Gardiner Technology control panels may
have additional markings as well as the Gardtec
800 Series
legends. These additional
markings are disregarded within this manual.
They may also have three extra terminals marked as follows:-
E/E -VE
E/E +VE
TMP+
These terminals are not applicable to the Gardtec
800 Series
therefore the two
factory fitted links to these terminals should be left in place, the links are as
follows:-
E/E-VE is linked to E/E+VE
TMP+
is linked to 0V
The keypad port on the master control panel is situated on the bottom edge of the PCB
towards the right hand side. Wiring to the RKP(s) is terminal to terminal as shown in
the following illustrations.
Fig 9. Single RKP wiring.
NOTE: RKP terminal positions may differ (dependent on model)
12V 0V CLK DATA DATA SPKR
A
B
DATAB DATAA CLK OV 12V SPKR
Control Panel
RKP
Keypad Wiring
Keypads may be wired in 'Star' format (each keypad being wired back to the master
control panel) see Fig 7a, or 'Daisy Chain' format (from the control panel to the first
keypad then onto the second keypad etc) see Fig 7b. It is also possible to wire the
keypads with a mix of 'Star' and 'Daisy Chain' formats see Fig 8.
Fig 7a. 'Star' format wiring.
Fig 7b. 'Daisy Chain' format wiring.
Fig 8. Mix of 'Star' and 'Daisy Chain' wiring.
Note: All keypads need to be numbered via the onboard ident jumper switches.
Note: ACE receivers count as RKPs and may only be numbered as RKP 1 or 2
(unless built into RKP).
Master
Control
Panel
Master
Control
Panel
RKP 3
RKP 4
RKP 4
RKP 1
RKP 2
RKP 3
RKP 4
RKP 1
RKP 2
Master
Control
Panel
RKP 1
RKP 2
RKP 3
GARDTEC
800 Series
GARDTEC
800 Series
4344R12.qxd 03/09/99 11:09 Page 16
