First use
18
Attaching the extra handle
CAUTION!
Risk of injury!
If the front handle has not been properly fixed in place, this may result in injury.
− Make sure that the gear tooth system has properly locked in place.
− Make sure that the locking screw has been tightened.
1. Insert the extra handle
1
into the mounting
20
on the upper suction tube
10
.
2. Use the screw
18
and the star nut
19
to fix the extra handle in the desired
position (see
Fig. C
).
3. When inserting the screw, make sure that the screw head reaches into the
hexagonal fixation.
4. Make sure that the gear tooth system of the mounting and the extra handle have
correctly locked into place.
You can later adjust the position of the extra handle by loosening the star nut.
Assembling the blower tube
1. Slide the sleeve
26
over the blower tube
25
following the arrow markings and
pull it up to the top of the blower tube (see
Fig. F
).
2. Snap the sleeve and the blower tube into position on both sides.
Do not disassemble the blower tube after it has been assembled.
Assembly in blower mode
1. Attach the assembled blower tube
25
to the receptacle on the motor housing
17
so that it clicks into position correctly (see
Fig. E
).
2. To remove the blower tube, push the lock button
16
and remove the blower tube
from the receptacle on the motor housing.
Assembly in vacuum mode
CAUTION!
Risk of injury!
If the collector bag is not secured during operation in vacuum mode, projected
parts could inflict injury.