44
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Cleaning / Storage / Transport
If you intend to store the equipment for longer than 30 days, the equipment must be pre-
pared accordingly. Otherwise the petrol still remaining in the carburettor will evaporate
and leave a rubbery sediment. This can cause problems when starting up the equipment
and may require expensive repairs.
1
Slowly remove the Petrol reservoir cap to release any pressure that may have formed
in the tank. Carefully empty the tank.
2
To remove the petrol from the carburettor, start the engine and let it run until the
equipment stops.
3
Leave the engine to cool (approx. 5 minutes).
4
Remove the spark plug (see section 10 "Change and clean the spark plug").
5
Add one teaspoon of 2-stroke engine oil into the combustion chamber. Slowly pull
the starter cord several times to apply a layer of oil to all internal components. Fit the
spark plug again.
Note: Store the equipment in a dry place and far away from possible ignition sources
such as an oven, a gas-fired hot water boiler, a gas-fired dryer, etc.
Putting the equipment back into operation
1
Remove the spark plug (see section 10 "Change and clean the spark plug").
2
Quickly tug on the starter cord to remove excess oil from the combustion chamber.
3
Clean the spark plug and check that the electrode gap is correct, or insert a new
spark plug with the correct electrode gap.
4
Prepare the equipment for operation.
5
Fill the tank with the relevant mixture of petrol and oil. See the section "Petrol and
oil".
Transport
m
Warning!
To reduce the risk of injury from loss of control and blade contact, never carry or transport
your 5 in 1 Petrol Tool with the cutting attachment moving. Always switch off the engine
and make sure the cutting blade has stopped before putting a 5 in 1 Petrol Tool down.
It may be carried only in a horizontal position. Grip the shaft in a manner that the machine
is balanced horizontally. Keep the hot muffler away from your body and the cutting at-
tachment behind you.
To transport the 5 in 1 Petrol Tool by car, empty the Petrol reservoir as described in section
8 "Draining petrol". Clean coarse dirt off the equipment with a brush or hand brush.
When transporting in a vehicle, properly secure it to prevent turnover, fuel spillage and
damage to the unit.
