38
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Maintenance
X. Maintenance
INJURY WARNING: Always wear protective gloves when working on or around cut-
ting tools.
Before performing any maintenance or cleaning work, always turn off the engine and
pull out the spark boot plug.
1. Do not spray the unit with water. It damages the engine.
2. Clean the unit with a cloth, hand brush, etc.
3. Use a moist piece of cloth to clean the plastic parts. Do not use any cleaning agents,
solvents, or sharp objects.
4. During the course of work, wet grass and weed wraps around the drive shaft below
the cutting guard for technical reasons. Remove this, otherwise the engine will over-
heat because of too much friction. (Fig. 38)
Regular checks
Keep in mind that following specifications relate to normal usage. Owing to circumstanc-
es (longer periods of daily work, severe dust exposure, etc.), the specified intervals will
become correspondingly shorter.
Before starting work, after tank filling, after impact or dropping:
• Check the cutting tools for secure seating, general visual check for cracks and damage.
• Immediately replace damaged or blunt cutting tools, even in the event of minor hair-
line cracks.
• Sharpen cutting tools (also when required).
Weekly inspection:
• Lubrication of gear (also, if necessary).
If necessary:
• Re-tighten accessible fastening screws and nuts. You will avoid excessive wear and
tear and damages of the 5 in 1 Petrol Tool, when you follow the instructions in this user
manual.
Replacing the line spool/cutting line (Fig. 24-29)
1. Pull off the line guard cap (A6) from the line spool (A7) by forcefully pressing between
the retaining plates of the line spool housing (A8).
2. Remove the line spool (A7) with line remaining and the compression spring.
3. Remove the used up spool.
4. Take the new line spool and pull out 10 cm at both lines each.
5. Now, place the line spool (A7) on the tapered spring, and guide both lines each
through the round metal lugs at the line guard cap (A6).
