40
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Maintenance
plug (A10) must be replaced with an equivalent plug.
• A strong incrustation of the spark plug (A10) can be caused by: Amount of oil is too high
in the petrol mix, poor oil quality, old petrol mix, or plugged up air filter.
• Screw the spark plug (A10) by hand completely into the thread. (Avoid jamming it)
• Use the supplied spark plug wrench (10) to tighten the spark plug (A10).
• When using a torque wrench, the tightening torque is 12-15 Nm.
• Plug the spark boot plug (A9) correctly on the spark plug (A10).
Clean the air filter (Fig. 32-35)
Soiled air filters reduce the engine power by supplying too little air to the carburettor.
Dust and pollen plug up the pores of the filter made of foamed plastic. Regular checks
are therefore essential.
• Disassemble the air filter cover (A11) by turning the fitting screw anti-clockwise and re-
move the sponge filter element (A12).
• To avoid objects falling into the air tank, replace the air filter cover (A11).
• Wash the filter element in warm soap water, rinse and allow drying naturally.
Important: Never clean the air filter with petrol or inflammable solvents.
In order not to shorten the service life of the engine, a damaged air filter must be re-
placed at once.
• Install the sponge filter element (A12) in reverse order.
m
Warning!
Never run the engine without the air filter element installed.
Care of the guide rail
Turn the rail around every time you have the saw chain sharpened or replaced. This will
avoid a one-sided wear of the rail, especially at the top and bottom.
Regularly clean
1 = the opening for the oil supply
2 = the oil passage
3 = the raceway groove of the rail
Servicing and sharpening of saw chain
Working effectively with the chain saw is only possible if the saw
chain is sharp and in good condition. This also reduces the risk of
kickback. The saw chain can be re-sharpened by any dealer. Do not
attempt to sharpen the saw chain yourself unless you have the necessary special tools and
experience. A properly sharpened saw chain goes way through the wood and it requires
very little pressure. Do not work with a dull or damaged saw chain. It increases physical
exertion, increase the vibrations and leads to unsatisfactory results and higher wear.
• Clean the saw chain.
3
2
1
