1300 922 271
7
AFTER SALES SUPPORT
MODEL NUMBER: BG-AW 1136, 04/13
the delivery rate.
• All shut-off devices (spray nozzles, valves etc.) in the
pressure line must be fully opened when priming so
that any air in the intake line can escape.
Starting Up
9
• Set up the pump on flat and firm ground.
• Attach the intake line ready for use.
• Unscrew the water filler screw (3) and remove the
coarse filter (5) together with the non-return valve
(6) as shown in Figure 2. Now you can fill the pump
housing with water. Filling the intake line accelerates
the priming process.
• Assemble in reverse order.
• Plug into the mains.
• Depending on the suction height and the amount
of air in the intake line, priming can take anywhere
between 30 seconds and 5 minutes. If it takes longer
than this, the pump should be refilled with water.
• If the pump is removed again after use, it must
always be refilled with water whenever it is
connected and used again.
9.1 Operating the flow switch:
You can select one of the four operating modes with
the MODE button.
POWER ON mode:
The equipment is in standby mode.
EVER ON mode:
The equipment will run continuously. Important:
Never let the equipment run against pressure over
a longer period (without drawing water). Danger of
overheating!
AUTOMATIC mode:
L = The equipment is drawing water (pump is running)
P = The equipment is building up pressure (e.g. the
water tap is closed) and then switches off
automatically.
TIME mode:
1. TIME NOW (current time): First press the SET button,
then you can enter the time with the SET and MODE
button. Confirm your entry by pressing the CHECK
button.
2. TIME ON (switch-on time): Proceed as described
under TIME NOW.
3. TIME OFF (switch-off time): Proceed as described
under TIME NOW.
4. Check TIME ON and OFF again, then confirm by
pressing the CHECK button.
The programming is now completed. Confirm that the
water tap opens at the programmed time.
Maintenance instructions
10
• To ensure a long service life, we recommend regular
checks and care.
Warning!
Before every servicing, switch off the pump
and remove the plug from the socket.
• If the pump is not going to be used for a long time or
has to be removed for the winter months, rinse it out
with water, empty it completely and allow it to dry.
• If there is a risk of frost, the pump must be emptied
completely.
• After long stoppages, make sure the rotor turns
correctly by briefly switching the pump on and off.
• If the pump becomes blocked, connect the pressure
line to the water line and remove the intake hose.
Open the water line. Switch on the pump several
times for approx. 2 seconds. Most blockages can be
removed in this way.
10.1 Cleaning the coarse filter insert
• Clean the coarse filter insert at regular intervals, and
replace it if necessary.
• Remove the coarse filter screw and coarse filter
together with the non-return valve .
• Do not use abrasive cleaning agents or petrol to clean
the coarse filter and the non-return valve. Clean the
coarse filter and the non-return valve by tapping
them on a flat surface. In cases of stubborn dirt, first
clean with soapy water, then rinse with clear water
and air-dry.
• Assemble in reverse order.
Replacing the mains cable
11
Warning!
Disconnect the pump from the mains! If the mains
cable is defective, it must be replaced by an electrician.
Ordering replacement parts
12
Contact our After Sales Support on 1300 922 271 and
quote the following data when ordering replacement
parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
