1300 922 271
6
AFTER SALES SUPPORT
MODEL NUMBER: BG-AW 1136, 04/13
• If possible, please keep the packaging until the end
of the warranty period.
IMPORTANT
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suffocating!
• Garden Pump
• Operating Instructions
• Quickstart Guide
• Warranty Certificate
• Warranty Sticker
Proper use
4
Applications
• Irrigation and watering of green areas, vegetable
beds and gardens.
• Operation of lawn sprinklers.
• For drawing water from ponds, streams, rainwater
butts, rainwater cisterns and springs for supplying
service water
Transport media:
• For the pumping of clear water (fresh water),
rainwater or light suds/service water.
• The maximum temperature of the fluid must
not 35°C if the equipment is operated
permanently.
• Do not use the equipment to pump inflammable,
gassing or explosive fluids.
• The pumping of aggressive liquids (acids, alkalis,
silo seepage etc.) as well as liquids with abrasive
substances (sand) must likewise be avoided.
• This equipment is not designed to convey drinking
water.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
Technical Data
5
Mains supply:
230V ~ 50 Hz
Power rating:
1100 W
Delivery rate max.
3600 l/h
Delivery height max.
46 m
Delivery pressure max.
0.46 MPa (4.6 bar)
Suction height max.
7 m
Delivery and intake con-
nection:
33.3 mm (R1 IG)
Water temperature max.
35°C
Protection type
IP44
Electrical connections
6
• Connect the power cable to a 230 V ~ 50 Hz earthed,
10 amp fuse minimum.
• The appliance is switched on and off using the
integrated ON/OFF switch.
• The motor is protected against overloading or
blocking by an integrated thermostat. In the event
of overheating, the thermostat switches off the
pump automatically. The pump will start up again
automatically after it has cooled down.
Fitting a suction pipe
7
• Screw an intake hose (min. 19 mm (3/4“ ) plastic hose
with spiral reinforcement) either directly or with a
threaded nipple to the pump’s intake connection (33.3
mm (R1)) (see Fig. 1).
• The intake hose should rise from the water pick-up
point to the pump. Always avoid laying the intake line
higher than the pump. Air bubbles in the intake line
delay and hinder suction.
• The intake and pressure lines must be attached in such
a way that they do not place the pump under any
mechanical strain.
• The intake valve should be so far immersed in the
water that the pump cannot run dry even if the water
level falls.
• If the intake line is not air-tight, the intake of air will
hinder the intake of water.
Pressure line connection
8
• The pressure line (should be at least 19 mm (3/4“))
must be connected to the pump’s pressure line
connection (33.3 mm (R1)) either directly or via a
threaded nipple.
• A 13 mm (1/2“) pressure hose can also be used with
the appropriate screw connections, but this will reduce
