HTW250/240P
Introduction
AFTER SALES SUPPORT
9
00800 4003 4003
MODEL: HTW250/240P PRODUCT CODE: 64055 xx/2017
Starting with cold engine (Fig. 1)
1. Slide the ON/OFF switch (6) to the position 'I'.
2. Carefully press on the fuel pump (11) several times until fuel comes into the
pump.
3. Slide the choke (4) to 'cold start'.
4. Slowly pull the cranking rope with its handle (5) until you feel a resistance.
5. Pull the cranking rope quickly and then guide it back slowly. Do not fully pull
out the cranking rope and do not allow the cranking handle to strike against the
engine.
6. When the engine starts slide the choke (4) to 'warm start and work'.
7. Allow the device to warm up for approx. 1 minute before starting the work.
Stopping the engine (Fig. 1)
1. Release the throttle trigger (14).
2. Slide the ON/OFF switch (6) to the '0' position.
Starting with warm engine (Fig. 1)
1. Slide the ON/OFF switch (6) to the position 'I'.
2. Slide the choke lever (4) to 'warm start and work'.
3. Hold the cranking handle (5) and pull the cranking rope until the engine starts.
Throttle lock-out switch (Fig. 1)
1. Hold the hedge trimmer on its rear handle (15) and press the throttle lock-out
switch (7).
2. Hold the front handhold (3) with your other hand.
3. Press the throttle trigger (14).
4. The cutting device will start moving.
• If you release the throttle trigger, the cutting device will stop and the engine will
idle.
If the cutting device runs in spite of non-pressed throttle trigger, you have to reduce
the idle speed. (See 'Maintenance'.)
AUS
HTH250/240P
Attachment and operation
AFTER SALES SUPPORT
19
1300 855 831
MODEL: HTH250/240P PRODUCT CODE: 59823 03/2018
