Layout/Scope of delivery
HTW250/240P
10
AFTER SALES SUPPORT
00800 4003 4003
MODEL: HTW250/240P PRODUCT CODE: 64055 xx/2017
has increased due to normal wearing of the cutting device after a longer period of
use.
To obtain good cutting results the free motion between the blades and the sword
must be correctly adjusted.
For this proceed as follows:
1. Loosen the nuts (A) on the top surface of the cutting device with the open end
wrench (16).
2. Slightly tighten the screws (B) on the underside with the allen key 4mm (17) (if
required loosen them previously).
3. Turn the screw (B) back anticlockwise by a quarter up to a half turn.
4. Use the allen key 4mm (17) to hold the screw (B) and firmly tighten the nuts.
The sliding play is correctly adjusted if the washer under the screw head can
just be freely moved back and forth by hand.
5. Lubricate the cutting device using environmental-compatible lubricating oil.
If the play is too small, this may cause a great extent of heating and thus damage to
the device.
Lubricating the gearbox (Fig. 1)
Lubricate the gearbox every 10 to 20 operating hours.
1. Put the grease gun onto the zerk fitting (10).
2. Force some grease into the zerk fitting (10).
Adjusting the idle speed (Fig. 4)
If the cutting device continues to run while the engine idles, you have to correct the
idle speed.
1. Allow the engine to run warm for 3-5 minutes (no high speed).
2. Turn the adjusting screw (C):
Clockwise
- idle speed increases (+)
Counterclockwise
- idle speed decreases (–)
Contact the manufacturer if the cutting device still continues to run in idle mode.
Do not continue working with the hedge trimmer in such a condition.
AUS
Maintenance, cleaning and servicing
HTH250/240P
24
AFTER SALES SUPPORT
1300 855 831
MODEL: HTH250/240P PRODUCT CODE: 59823 03/2018
