S
U
A
1800 909 909
www.powertoolsupport.com email: [email protected]
AFTER SALES SUPPORT
43668
17
5
Cutting height adjustment
WARNING:
Stop the engine and unplug the spark plug before
any repairs or maintenance operations.
The mower has one lever to easily adjust the cutting height. There
are 8 height settings.
1. To decrease the cutting height pull the height adjustment lever
(6) out and move it up a notch, towards the handlebar.
2. To increase the cutting height pull the lever out and move it down a notch,
towards the engine.
3 After adjustment, ensure the lever is fully located in the
selected notch.
Adding and Checking the oil
IMPORTANT:
The motor of this mower is packed with NO OIL
in the motor. Prior to starting the motor, Oil MUST be added to
the sump of the motor.
Failure to add sufficient oil will result in damage to the motor
which is NOT covered under the warranty of the mower.
On a new mower, the motor needs to be filled with 400ml’s of
SAE 10W/30 engine oil.
Each time the mower is used, the oil level should be checked
and if low, add sufficient oil to ensure the oil level is to the
full mark on the dip stick.
1. Position the lawn mower on a flat and level surface.
Clean the area directly around the oil filler cap.
2. Remove the oil filler cap by turning approx half a turn in a anti
clockwise direction and lift the cap outwards. Note: the cap is
not a threaded fit but a bayonet type fit. Clean the dip stick
with a clean cloth, cleaning away any visual oil.
3. FOR A NEW MOWER, add 400ml of SAE 10W/30 engine oil.
4. For both a new mower and also a previously used mower,
measure the amount of oil in the motor by replacing the oil
cap / dip stick on top of the plastic oil fill surround. ie do not
engage the bayonet.
5. Leave the oil cap on top of the oil fill surround for a few seconds and then remove
and inspect the oil level on the bottom of the dip stick.
Instructions