Ganz ZT-PTS Series, Instruction Manual

Page: 6 / 23

010 011
ZT-PTS
SERIES
ZT-PTS
SERIES
B-1. When you install Camera on the pole, make 4 holes at edge with Ø13 in
diameter and 37mm in depth.
Make also a hole for the cables with about Ø30~50 in diameter in the
bottom center of the bracket. (FIG.6)
B-2. Pass the cables of the camera through the inside of Pole Stand and connect
the Camera to the Pole Stand with pieces of M4*16 screws. (FIG.7)
B-3. Connect the Safety Wire of the camera to the bracket.
In order to avoid getting entangled in the camera, fasten the Safety wire to
the bracket with Cable Tie. (FIG.8)
Installation
B. Pole Stand
1. POLE STAND 1EA
2. BOLT & NUT M10 4EA
3. FLAT WASHER 4EA
4. SPRING WASHER Ø10 4EA
5. SCREW M4 x 16 5EA
6. SPRING WAHGER Ø4 5EA
7. WRENCH (3mm)
1EA
8. MANUAL
CONTENTS
(M4 x 16 - 4EA)
Installation
B-4. Install 4 pieces of Anchor bolt in the Ø13 holes at the edge and connect the
cables.
B-5. Adjust the Camera and Pole Stand to M10 x 45 Bolt and Flat Washer, Spring
Washer. And then tight enough with Nuts. (FIG.10)
(M10 x 45 - 4EA)