Ganz ZT-PTS Series, Instruction Manual

Page: 5 / 23

008 009
ZT-PTS
SERIES
ZT-PTS
SERIES
Installation
A. Ceiling Mount Bracket
A-2. Connect the Ceiling Mount Bracket to the Camera with 4 pieces of M4X16
screws and spring washer. (FIG.2)
A-3. Connect the Safety wire of the Camera to the Bracket. In order to avoid
getting entangled in the Camera, fasten the Safety wire to the bracket with
Cable tie. (FIG.3)
A-1. When you install Camera on the ceiling, make 4 holes at the edge with Ø13
in diameter and 37mm in depth. If you want to connect the cables from the
inside of the ceiling, also make a ole for the cables with about Ø30~50 in
diameter in the center of 4 edges. (FIG.1)
1. CEILING MOUNT BRACKET 1EA
2. SET ANCHOR BOLT (W5/9) 4EA
3. SCREW M4 x 16 5EA
4. SPRING WASHER Ø4 5EA
5. WRENCH (3mm) 4EA
6. MANUAL
CONTENTS
(M4 x 16 - 4EA)
Installation
A-4. When you want to connect the cables from the inside of ceiling, pass the
cables through the ceiling. When you want to connect the cables from the
outside of ceiling, remove the hole cap from the side of the bracket and pass
the cables through the hole.
A-5. Install 4 pieces of Anchor bolt in the holes at the edge and tight enough
with Nuts. (FIG.4)
A-6. Connect the cables referring to the page 8. (FIG.5)