Ganz zn-d9024nha, Instruction Manual

Page: 9 / 12

EG-9
Adjusting the camera direction
The camera body is set in a tri-axial mounting allowing movement in
the pan, tilt, and rotational planes.
1
Adjust the direction of the lens so it faces the subject.
Attention
Using the camera in a near-horizontal position will show the camera cover
on screen.
Forcibly adjusting the camera to point in directions beyond the limits of
the mounting may cause the cable to catch on internal components and
damage the camera.
When adjusting the rotation or vertical direction of the camera, be sure to
hold the rotary ring, not the lens. When holding the lens for adjustment,
normal images cannot be obtained.
2
When you have fi nished adjusting the direction of the lens, tighten the
locking screw with a screwdriver.
Installation of a microSD card
When a microSD card that is sold separately is
used to save images, insert it into the microSD
card slot.
Attention
Be sure to FAT-format a microSD card with Windows
®
before using it.
When inserting or extracting a microSD card, be sure to turn off the power
source.
The upper limit of the microSD card is 2 GB, SDHC memory card is not
supported.
Attaching the service monitor
Use the service monitor cable to check
and adjust camera direction, focus, and
angle on a service monitor.
Switching to the service monitor mode
When using a service monitor, keep the
service monitor mode selection button
(green) pressed for 2 seconds.
To cancel the service monitor mode, keep the
service monitor mode selection button pressed
for 2 seconds.
While in the service monitor mode, the delivery of
signals to the network is stopped.
Service monitor mode
selection button (Green)
The service monitor is not supplied in the
cell. Please have one ready.
350º Pan
350º Rotation
180º Tilt
Indicates the top
of the camera
(US)ZN-D9024NTSC.indd 9 (US)ZN-D9024NTSC.indd 9 2009/02/27 17:15:05 2009/02/27 17:15:05