Installation Guide
18
3.4
Cables and Connections
The PTZ Camera is supplied with one integrated 22-pin Data Cable for connecting
with the power, video, and RS-485/audio input & audio output cables. Please read
the following sections thoroughly before making connections.
3.4.1
Cable Requirements
For operation, the PTZ Camera requires video, RS-485 and power cables as
described below:
•
The video cable sends video signals to a remote viewing site. Using a coaxial
cable to send video signals is recommended.
•
RS-485 cable carries commands from a control device to the dome cameras. A
CAT 5, 24 gauge cable is recommended.
•
Power supply: AC 24V output voltage
NOTE: Ensure power supply meets the PTZ Camera’s power requirement,
or product impairment will occur. If any mistake happens, please contact with
a qualified maintenance engineer.
3.4.2
22-Pin Data Cable
A data cable (see the figure below) is shipped with the PTZ Camera for quick
installation for demo or testing usage.
NOTE: If the power lines use three wires, make sure the Ground wire is
inserted into the mid-pin of the terminal block as shown in the figure above.
Summary of Contents for ZC-PT236
Page 1: ......
Page 78: ...Installation Guide 77...
