![background image](http://html1.mh-extra.com/html/ganz/c-allview/c-allview_installation-manual_3423022008.webp)
8
The supplier installed mains input cable to the RCPS1 should have an isolator
fitted and be fused according to its gauge and local electrical regulations.
Failure to observe such regulations may result in injury or death
Telemetry Control
The Camera unit is designed to be added to any telemetry controlled system by
providing compatibility to a number of industry standard control protocols. This can
be done by directly using the on-board protocols or by adding a third party protocol
converter to interface between an incompatible control protocol and one of the on-
board protocols.
Telemetry control is by RS485 or Co-axial video telemetry.
Due to the limitations or software changes of the some of the protocols, it is not
always possible to implement all of the features of the Camera unit with the Original
Manufacturers protocol, thus some features on a manufacturers keyboard, may limit
the way the Camera unit can operate.
Using RS485 based telemetry camera addresses are limited to 127 addresses.
On-Board Protocols
The Camera unit has the following on board protocols:
American Dynamics / Sensormatic RS422 (uni-directional only)
BBV Coaxial Telemetry
CBC C-Dome RS485
DeView
[VTC]
Kalatel
DP
Overview
RS485
Pelco
Co-Axitron
Pelco D 2400 baud
Pelco P 4800 baud
Pelco P 9600baud
DIL Switches
All addressing and protocol selection is set by 2 banks of 8way DIL switches located
on the main body of the housing, underneath a removable weatherproof cover.
Cover retained by
two screws
Screws and cover
removed