![background image](http://html1.mh-extra.com/html/ganz/c-allview/c-allview_installation-manual_3423022005.webp)
5
Mounting
The Camera unit is designed to be mounted upright or inverted. By the nature of its
manufacture, it is a heavy item, thus it requires a substantial and stable mounting.
Each Camera unit is supplied with a 4” (101.6mm) PCD mounting adaptor to allow
mounting to industry standard brackets, tower and columns.
The adaptor as two cable entry points:
1. A pass-through hole in the plate to allow cabling through a column or tube
type mounting.
2. A M25 conduit thread in the side wall to permit flexible conduit to be
connected to the adaptor.
Figure 1
This adaptor should have the composite cable threaded through it before it is
mounted to the column or bracket. The cable should be dressed such that approx
25~35mm of the weatherproof connector is protruding out of the smaller plate that
connects to the Camera unit.
Figure 2
The 4” (101.6mm) PCD plate should then be mounted to bracket or tower using M8
bolts, washers and Ny-Loc type nuts.