Gantner GAT Vending 6100 BA, Installation, Configuration & Operation

Page: 28 / 48

GAT Vending 6100 BA
Startup and Configuration
28
HB_GAT-VENDING6100BA--EN_121
www.gantner.com
The configuration settings of the GAT Vending 6100 BA are organized into several categories. The directory on the
left (1) lists the different configuration categories.
► Click on a category and the settings for this category can be viewed and adjusted in the field to the right (2).
o
A short description of the setting is shown at the bottom of the window (3).
An overview of all the GAT Vending 6100 BA configuration settings is available in
section “5.3.4 List of
Configuration Settings
”. More information on the operation of GAT Config Manager is available in a separate
manual.
5.3.2 Project Configuration
Complete the following steps to configure the GAT Vending 6100 BA via a project in GAT Config Manager.
► Click on the “Create Project” icon (2 in Figure
5.17 ) to start a new project.
► When a project for the GAT Vending 6100 BA already exists, click on the “Open Project” icon (1 in Figure
5.17 )
to open the existing project.
Figure 5.17 - GAT Config Manager
– project setup
► Once a project is established, click on the “Scan Device” icon (1 in Figure
5.18 ).
o
The software scans the network and displays a list of all connected GANTNER devices.
► Select the GAT Vending 6100 BA requiring configuration from the list. Use information such as the IP and MAC
address to identify the correct device.
o
The selected device is highlighted in blue as shown in Figure 5.18 .
► Click on “OK” (2 in Figure
5.18 )
o
The selected device is added to the “Devices” list (3 in Figure
5.18 ).