Gantner GAT Vending 6100 BA, Installation, Configuration & Operation

Page: 33 / 48

GAT Vending 6100 BA
Startup and Configuration
www.gantner.com
HB_GAT-VENDING6100BA--EN_121
33
5.3.4 List of Configuration Settings
The following table lists all the configuration settings available for the GAT Vending 6100 BA in GAT Config
Manager. A brief description and the format (where applicable) for each setting are shown in the table. Make sure to
enter data in the indicated format for settings such as time definitions, etc.
Options Description Format Default
Communication
Ethernet
Port number Port used for communication with the device Integer 8000
MAC address
The MAC address of the device (cannot be changed) Integer
DHCP enabled If enabled, will use the IP settings from a DCHP server Boolean True
Static IP address IP address of the device if DHCP is disabled IPv4 add. 192.168.1.37
Static subnet mask Subnet mask of the device (if DHCP is disabled) IPv4 add. 255.255.255.0
Static primary DNS Primary DNS address of the device (if DHCP disabled) IPv4 add. 192.168.1.13
Static secondary DNS Secondary DNS address of the device (if DHCP disabled) IPv4 add. 192.168.1.11
Static default gateway Default gateway of the device (if DHCP is disabled) IPv4 add. 192.168.1.6
NetBIOS name NetBIOS name of the device Text GW + Part No.
+ Serial No.
Dynamic IP address IP address got from the DHCP Server IPv4 add. 0.0.0.0
Dynamic subnet mask Subnet mask got from the DHCP Server IPv4 add. 0.0.0.0
Dynamic default gateway
Default gateway got from the DHCP Server IPv4 add. 0.0.0.0
100 MBit Ethernet enabled Option to enable 100 MBit Ethernet link, 10 MBit if
disabled Boolean true
Port Debug UDP port to assist service technicians with fault diagnosis Integer
Ident Message Timeout Timeout setting for the commands "Card Ident Request"
and "Product Vending Request" Integer
Protocol
Communication mode Operating mode of the device. Select between
“Online”, “ Emergency” or “Offline” Menu Online
Hardware
Display
Contrast Contrast of the display. Range: 0
– 63. 0: Set to default
Integer
Brightness active mode Brightness of the display when the device is in
standard operation mode. Range: 0 - 80 Integer
Brightness active mode Brightness of the display when the device is in energy
saving mode. Range: 0 - 80 Integer
Energy save delay Idle time in milliseconds before the device switches to
energy saving mode. Integer
Application
General
Sound signals enabled Turn on/off sound signals emitted after user activity Boolean true
Time format Format used to display time values on the device.
Select “0 – 24”, “AM / PM” or “Disable” Menu 0 - 24
Use alternative font Select to use the alternative font for displaying text Boolean False
Font loaded Description of the currently loaded font data
Device License License to enable special features of the device Hex
0000…
Disable Secure UID Option to disable the Secure UID Boolean False
Data handling
Locker 1
Read
Option to read data from the first locker segment of the
data carrier and send to host Boolean False
Locker 2
Read Option to read data from the second locker segment of
the data carrier and send to host Boolean False