G&D RemoteAccess-GATE, Installation Manual

Page: 30 / 40

Initial configuration
8 · G&D RemoteAccess-GATE
3. Enter the following values under Ethernet > IPv6 :
4. Enter the following values under
Ethernet > Interface Settings
:
5. Enter the following values under
Common Network Settings
:
6. Click on Save .
Enable IPv6: Enable or disable IPv6 protocol
IP Auto

Configuration:
Select the method by which the IPv6 settings are set:
 Static:
Enter a static IP address.

DHCP: Obtain IP address from a DHCP server.
IP Address/

Prefix Length:
Assign a static IPv6 address and specify the prefix length.
NOTE: This setting is only available when using a static IP
address (
Static
).
Default Gate-
way
Enter the IP address of the gateway.
NOTE: This setting is only available when using a static IP
address ( Static ).
Preferred 
Hostname:
Enter a preferred hostname.
NOTE: This setting is only available if the IP address is
obtained by a
DHCP
server.
Speed: Select the speed of the LAN connection:
Auto , 10 MBit/s , 100 MBit/s or 1 Gbit/s
Duplex: Select the duplex mode of the LAN connection.
Auto
,
Full
or
Half
DNS Resolver

Preference:
Define which IP address is used when the DNS resolver
returns both Ipv4 and Ipv6 addresses.
DNS Suffixes 
(optional)
If necessary, enter a DNS suffix.
First/Second

DNS Server:
Enter the IP address of the DNS server.
NOTE: If DHCP or Auto is selected for the IPv4/IPv6 settings
without the definition of static DNS servers, the device uses the
DNS servers assigned by DHCP.