String Reel Holder Installation
The string reel holder pin is an 8 mm rod with threads on
both ends, and flat surfaces machined on one end.
Thread the end of the pin without the flat surfaces into the
threaded boss on the right side of the lower column
support. Using the M6 open end wrench positioned on
the flat surfaces, securely tighten the pin to the lower
column support.
The string reel holder can hold up to 5 reels of string
(depending on the size of the string reel). Before placing
the first reel on the pin, slide two M8 washers over the pin
and slide them to the boss on the lower column support.
After the first reel is placed onto the pin, place two
spacers between each reel to provide enough space
between reels and allow them to turn freely without
rubbing against one another. (To provide a smooth feed
to the String Length Meter, place the reels on the pin so
the string spools off the reel from the underside of the
reel.)
After the last reel is installed, place the remaining
spacer(s) on the pin and attach the threaded knob to the
end of the pin.
7
