14
KEEP THIS MANUAL
8.
STORAGE, MAINTENANCE & CARE
Winter or Extended Storage (more than 72 hours)
Within the floating sensor there is a sensing node that must be moist at all times.
When you remove the sensor from the water, it is important to close and lock the
end cap (see below). This is especially important if the sensor will be out of water
for longer than 72 hours (3 days). Store it indoors, in a COOL, DRY environment.
NOTE: Extreme temperatures can harm the sensor during storage.
Do not store in freezing temperature (a garage for instance).
ePOOL is programmed to show this message October
15th each year. If you are going to remove it from
your pool, follow these instructions. If not, simply
press NEXT.
1) UNPLUG the receiver power cord from the
wall outlet.
2) Remove the ePOOL sensor from the pool or spa.
Remove the batteries and disconnect the power
connector. Carriage may be left inside the unit.
3) Reassemble and close handle.
The sensor CLOSURE CAP must be secured in the
CLOSED-LOCK position during extended storage.
Please ensure you the sponge is moist and inside
the bottom of the cap.
4) Twist the CAP counter-clockwise and at the
same time push with an upward motion. Then
twist the CAP clockwise into the CLOSED-LOCK
position. This position allows an internal sponge
to keep the sensor nodes moist.
Sponge
Sensor Nodes
Sensor Lok-Ca
Closed Open
