8
KEEP THIS MANUAL
6. SENSOR
SETUP
Your pool or spa should be adjusted to the proper chemical balance
before using the ePOOL system. For BEST results, we recommend taking
a sample of your pool or spa water into your local pool supply retailer for
a free water chemical analysis and bring your pool into balance before
placing the floating sensor in your pool. ePOOL is not guaranteed to
work on pools or spas with grossly unbalanced chemical levels.
1) Remove the protective plastic wrap
from the ePOOL sensor. Twist the ePOOL
sensor LOK-CAP into the OPEN position
by turning it counter-clockwise and
pulling downward. Then turn the cap
clockwise until it clicks into the open,
locked position. If the cap comes
completely off, slide it back on and
turn clockwise at the top notch.
FOR BEST RESULTS: We recommend you remove the sponge
from the Lok-Cap before placing the unit in the water.
Keep the sponge for winterizing and/or storage.
The ePOOL sensors require a moist environment during transit.
Upon opening the sensor LOK-CAP, some liquid may spill out.
This water-based solution is non-toxic. A moist sponge is
mounted inside the cap to provide a moist environment for
the sensors during periods of extended storage.
2) Turn the thumbscrew counterclockwise
to unlock the handle. Open the handle.
Remove the screws from the cover and
take off the cover.
3) Remove the battery carriage and insert
batteries. Plug in the battery carriage and
insert into the product.
4) Replace the cover and reassemble. Make
sure the screws are fastened securely to
ensure a water-tight seal.
5) Close and lock the handle.
6) Place the sensor into the pool or spa.
7) Place the receiver in the desired location in your home (for best results,
location is a window with line of sight to the pool).
8) Plug the adapter into a wall outlet and the other end into the receiver unit.
9) Follow the on-screen setup instructions in the next section.
Sensor Lok-Cap
Closed Open
