Instruction Manual : 6’ X 6’ HYBRID BLIND
23
STEP 15
FIGURE 15
FIGURE 16
STEP 16
15. Drape the roof panel (41) over the assembled roof
frame. Secure the hook and loop attachment strips
on the front and the back of the roof panel to the
strips on the front and back wall panels and top
tier of blind frame. Adjust and redo as necessary to
take out as much slack in the fabric as possible. SEE
FIGURE 15 and DETAIL I.
Wrap the corners of the roof panel around the
corners of the frame assembly and secure hook strip
to loop. SEE FIGURE 15 and DETAIL J.
Pull the roof panel tight by wrapping D-ring straps
around top tier of blind frame poles (4, 5). Feed the
long strap through both D-rings and back through
to tighten. SEE FIGURE 15 and DETAIL K.
16. Locate the following parts: door frame top (11), two
bottom door frame parts (12, 13), pole (14), two
complete cam straps (38) (both cam strap end and
long loop end), and door panel (47).
Slide a cam strap end onto each part (12, 13) as
shown. SEE FIGURE 16. Then slide (12, 13) into
the sleeve in door panel (47) so that snap buttons
secure the parts together inside of the sleeve as
shown. SEE FIGURE 16 and DETAIL M.
Slide door frame top (11) onto assembled door
frame bottom so that snap pins secure the parts
together. SEE FIGURE 16.
Slide pole (14) into top sleeve of door panel being
sure to also slide on the two long loop ends of cam
straps (38) as shown. SEE FIGURE 16 and DETAIL L.
DETAIL I
DETAIL J
DETAIL K
11
13
12
47
14
41
38
38
DETAIL M
DETAIL L
