Instruction Manual : 6’ X 6’ HYBRID BLIND
24
STEP 17
FIGURE 17
FIGURE 18
STEP 18
17. With the door panel (47) laid out flat, flip the
assembled door frame over onto the panel. Then,
flip pole (14), top edge of panel and the two long
ends of cam straps over the frame. SEE FIGURE 17.
Feed the loop end of straps through the cam
buckles and stand the door upright. Tension the
door panel vertically by pulling down on the loop
end of the strap with one hand and up on the loose
end with the other. DO NOT OVER TENSION THE
PANEL. ONLY TENSION ENOUGH TO TAKE THE
SLACK OUT OF THE PANEL VERTICALLY AT THIS
TIME. SEE FIGURE 17.
Wrap the edge of the door panel on the door
handle side around the door frame and secure with
hook and loop strips. The opposite edge will be
attached with hook and loop strips to the left front
wall panel (44) in a later step. SEE FIGURE 17.
Secure the door panel to the frame with the two
hook and loop straps on the interior of the blind.
SEE FIGURE 17.
18. Attach the assembled door to the blind frame by
sliding the plastic spacer (53) onto the post on (13)
and inserting the post into the hole in pole (31). SEE
FIGURE 18 and DETAIL O.
Secure the top of the door to pole (33) using a 1/4-
20 X 2-1/4 IN bolt (51), plastic spacer (53), plastic
washer (54), and 1/4-20 nut (56). SEE FIGURE 18
and DETAIL N.
Secure the edge of the door panel on the hinge side
to the front left wall panel (44) with the hook and
loop strip. SEE FIGURE 18.
Locate the door handle parts: door handle (40),
door handle latch (39), three plastic washers (55),
and 5/16-18 nut (57). Assemble as shown in DETAIL
P. Using a 1/2 IN wrench, tighten snugly. DO NOT
OVER TIGHTEN.
DETAIL O
DETAIL P
44
53
13
51
33
53
54
40 55
55 55
39
57
56
Hook
and Loop
Strap
Hook
and Loop
Strap
47
DETAIL N
14
