Instruction Manual : 6’ X 6’ HYBRID BLIND
15
ASSEMBLY INSTRUCTIONS
STEP 1
FIGURE 1
FIGURE 2
STEP 2
1. Open box, remove contents and organize all parts
together according to their labels. This step greatly
helps the ease of assembly.
Locate the four base hubs (1), three (6) poles, three
(7) poles, one (31) pole, one (32) pole and two door
hubs (9). SEE FIGURE 1.
Slide each (7) pole into the corresponding (6) pole
so that the snap button secures both parts together.
SEE FIGURE 1.
Slide the (32) pole into the corresponding (31) pole
so that the snap button secures both parts together.
SEE FIGURE 1.
Slide the two door hubs (9) down to the second
snap pin in assembled (31, 32) poles as shown so
that the snap buttons secure the parts together. SEE
FIGURE 1.
Slide the three assembled (6, 7) poles and one
assembled (31, 32) poles into the four base hubs (1)
so that the snap buttons secure the parts together.
You should now have the bottom tier frame of the
blind assembled. SEE FIGURE 1.
2. Slide the four (18) poles into the base hubs (1) so
that the snap buttons secure the parts together. SEE
FIGURE 2.
Slide the (15) pole and (17) pole into the door
hubs (9) so that the snap buttons secure the parts
together. SEE FIGURE 2. Be sure that the door stop
plate on pole (15) is facing interior of blind as shown
in DETAIL A.
DETAIL A
7
6
9
32
31
1
18
1
17
9
15
Do not tighten any nut and bolt combinations completely
until instructions indicate to. Finger tighten plus one turn
of a wrench only! This will temporarily hold the locknut on
the bolt while helping alignment of all parts!
Door
stop plate
6
7
6
7
