Instruction Manual : 6’ X 6’ HYBRID BLIND
17
STEP 5
FIGURE 5
FIGURE 6A
STEP 6A
5. Slide the four (19) poles into the middle hubs (2) so
that the snap buttons secure the parts together. Pay
attention to the orientation of the snap buttons. The
snap buttons must face each other as shown and
each through-hole must be located closer to the
top. SEE FIGURE 5.
Slide the (10) pole and (16) pole into the (30) parts
so that the snap buttons secure the parts together.
SEE FIGURE 5. Be sure that the door stop plate on
pole (16) is facing interior of blind.
6. Slide the (7) pole into the (6) pole so that the snap
button secures the parts together. SEE FIGURE 6A.
Slide a roof hub (3) onto each end of the assembled
(6, 7) poles so that the snap buttons secure the parts
together. SEE FIGURE 6A.
Slide each (4) pole into each (5) pole so that the
snap button secures the parts together. SEE FIGURE
6A.
Slide the assembled (4, 5) poles into the roof
hubs (3) so that the snap buttons secure the parts
together. SEE FIGURE 6A.
Slide the (34) pole into the (33) pole. Make sure that
the snap buttons on each pole are facing the same
direction and secure together using one 1/4-20 X 1
IN bolt (52) and 1/4-20 nut (56). SEE FIGURE 6A.
Slide the two door hubs (9) down to the second
snap pin in assembled (33, 34) poles as shown so
that the snap buttons secure the parts together. SEE
FIGURE 6A.
Slide the right and left front roof hubs (35, 36)
onto the assembled (33, 34) poles so that the snap
buttons secure the parts together. SEE FIGURE 6A.
Slide the assembled (9, 33, 34, 35, 36) onto the
assembled (4,5) poles so that the snap buttons
secure the parts together. SEE FIGURE 6A. You
should now have the top tier frame of the blind
assembled.
10
30
16
19
2
3
6
7
9
52
4
36
4
5
5
35
33
56
34
Through hole
closer t
o top
