Version 2, 18 December 2020, Page
12
of
12
Maintenance Instructions
Solenoid Valve:
−
Turn the water supply off and activate the push button to drain as much water from the installation
as possible, and then turn the power off at the GPO.
−
Depending on the location of the solenoid valve it may be more convenient to remove the solenoid valve
completely from the installation to service it.
−
The solenoid may be disassembled and checked for debris and cleaned to avoid potential damage to the
diaphragm. Please take note of the location of the components and reassemble in the correct order, as
there is a spring in the housing that may inadvertently spring out.
−
Service or replace the solenoid and re-install into the line. Push the power plug from the sensor back
onto the solenoid.
−
It is recommended that the line strainer be serviced and cleaned at this stage to ensure that dirt and grit
isn’t restricting the flow
−
Ensure the bypass tap on the valve is in the closed position
Push Button, Face Plate, Control Module and Power Transformer
These items are non-serviceable products. If damaged they must be replaced.
If there appears to be any problems with these items please contact Galvin Engineering.
Note: Before attempting to replace any of these items check that you have access to re-run the
connection leads. If you do not have access or you have any doubts, please contact Galvin
Specialised for advice before commencing replacement.
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer’s warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer’s warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer’s warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
