Galmet Easy Air Basic 2 GT, Operation & Installation Manual

Page: 5 / 20

- 5 -
OPERATION MANUAL AND WARRANTY CARD
"Galmet Sp. z o.o.”
6. Heat pump specifications
TYPE
EasyAir Basic 2GT
Catalog number 09-353100
Pump operation range
+7 +35ºC
Domestic hot water temperature
50ºC
Accumulator tank volume 200 L
Refrigerant R 134 a / 700 g
Dimensions: height x diameter 1500 x 670
Weight 125 kg
Power supply voltage 230V
Connection fittings
1” Internal Thread
Condensate connection 12 mm
Rated power consumption 600 W
Working pressure 6 bar
Average thermal power of the heat
pump 1.92 kW
Electric heater power 2 kW
Electrical protection B16
Air flow rate 300 m³/h
Compressor Embraco/Aspera
7. Maintenance:
a) check the connection between the plug, socket and earthing wire on a regular basis;
b) in colder regions (below 0º) while the system is to be shut off for a longer period, drain the
water to protect the internal tank against freezing and avoid damage to the heater;
c) to provide proper device operation it is recommended to clean the internal tank and heater on
a regular basis;
d) check the magnesium anode every year. If it is worn, replace it. For additional information
contact the supplier or a service centre;
e) if water parameters at outlet are sufficient, it is recommended to set a lower temperature to
reduce heat emission, prevent lime scale build-up and to save energy;
f) clean the air filter every month, while the evaporator should be cleaned once a year;
g) before you shut off the device for a longer period disconnect the power supply, drain water
from the tank and pipes and close all valves. Check all internal components on a regular basis.
8. Checking and moving the device
After the device delivery, check its packaging for any damage. If any damage is found, notify the
carrier of this fact immediately.
When carrying the device, take into account the following tips:
1. Fragile, handle with special care.
Hold the device upright to avoid damage to the compressor.
2. Before you carry the device check whether the route to the installation site is free from any
obstacles.
3. The device should be carried in its original packaging.
4. When lifting the device always use protectors to avoid damage to tapes and ensure the device
weight is properly balanced.