Galmet Easy Air Basic 2 GT, Operation & Installation Manual

Page: 18 / 20

- 18 -
OPERATION MANUAL AND WARRANTY CARD
"Galmet Sp. z o.o.”
20. Warranty Terms and Conditions
1. The heat pump warranty is granted for a period of 24 months from its first start-up, however not longer than
27 months from the date of manufacture.
2. The warranty period for the enamel-coated tank is 48 months, however no longer than for the warranty period
plus 12 months from the product date of manufacture.
3. During the warranty period any device defects resulting from the manufacturer's fault will be rectified free of
charge within 14 working days from the date of reporting.
4. The method of rectification is at the manufacturer's discretion.
5. It is mandatory to replace the tank magnesium anode at least every 18 months
(the anode should be inspected for wear every 12 months) - the replacement is not covered by the warranty
(keep the purchase invoice and the record testifying its replacement). A regular magnesium anode replacement is
required to maintain the tank warranty.
6. It is not allowed to install the heater without an operational safety valve (keep the safety valve purchase
document and its warranty card). The safety valve should be installed directly upstream the heater at the cold
water supply pipe. It is prohibited to install the heater in rooms where temperature can drop below 0°C.
7. The company or fitter carrying out: the installation, start-up, repair and maintenance inspections shall carry
out all works in accordance with good construction practices and must be a specialty company.
8. During the warranty period the warrantor provides a free of charge repair or rectification of a physical defect
of the contract subject, within the following periods:
a) 14 days from the date of making a claim, if the defect rectification does not require replacing structural
components of the contract subject;
b) 30 days from the date of making a claim, if the defect rectification requires replacing structural components
of the contract subject;
9. The warranty does not cover:
a) damage resulting from failure to use the device in compliance with generally accepted rules for such devices,
failure to follow the intended use recommendations and instructions provided by the manufacturer;
b) damage caused by the user;
c) products, where unauthorized interference has been found, including modifications, repairs carried out on
one’s own, construction changes;
d) damage resulting from improper installation and assembly;
e) improper device operation resulting from incorrectly chosen installation parameters
, controller settings, improper system venting, etc.
10. The device service covers the damage and defects resulting from the manufacturer's fault.
11. Assembly, electrical and hydraulic connections and device maintenance can only be carried out by an
authorized fitter.
The manufacturer shall not be held responsible for any damage to the device resulting from its improper
installation or failure to use the device following the instructions contained in this operation and installation
manual.
12. The method of warranty repair is at the device manufacturer's discretion. Except from its own service center
network, the warrantor allows for carrying out warranty repairs by other fitters authorized by him (to be
consulted beforehand).
13. No operating manual or no warranty card stamped by the shop and the fitter results in voiding the warranty
immediately. No entry documenting the first start-up date in the device inspection card of this manual results in
voiding the warranty immediately.
14. When the Buyer makes it impossible to carry out a warranty repair twice, despite the warrantor’s readiness to
carry it out, it is considered that the Buyer gives up the warranty claim.
"Galmet Sp. z o.o.” Sp. K.,
reserves the right to introduce changes in the specifications or models to improve
devices without prior notice. The manufacturer shall not bear any costs resulting from the above mentioned changes.
.