MPI DC
32
All copying, even partial, of this manual is strictly forbidden.
RG66007970 - Rev 01
15
InSTallaTIOn CleaRanCe ReQUIReMenTS
To guarantee the proper functioning of the unit and access for maintenance purposes, it is necessary to comply with the minimum installation clearance
requirements shown in figures 1 and 2�
There must be no obstacles blocking the path of the air flow from the fans�
Avoid any and all situations of backflow of hot air between air outlet and inlet of the unit�
If even only one of the above conditions is not fulfilled, please contact the manufacturer to check for feasibility�
In the design of the MPI DC series, special care has been taken to minimise noise and vibrations transmitted to the ground�
Even greater insulation may be obtained, however, by using vibration damping base supports (available as optional accessories)�
If vibration damping base supports are adopted, it is strongly recommended also to use vibration damping couplings on the water pipes�
Whenever the unit is to be sited on unstable ground (various types of soil, gardens, etc�) it is a good idea to provide a supporting base of adequate
dimensions�
Warning
heat pump units produce condensation while operating in the heating mode�
MPI DC 08
CoIl PluMBInG ConnECTIon SIDE
El
ECTRIC C
on
TR
ol
B
oARD
Co
Il SIDE
