• Encoders and ENTER
,
ESC buttons
The DS-CP25 is equipped with 3 Relative Encoders, “NAV/PM1”, “PM2” and “PM3”. These encoders
allow you to navigate the user interface and edit sections of the processor. They allow the user to
navigate within the screen for the selection of sub-menus, pages and parameters and to select the
values to be assigned during the editing operations.
The “ENTER” and “ESC” buttons allow the user to confirm or NOT confirm the operations performed by the
encoders.
• UTILITY
,
EQ Edit
/
Mute
[
2
]
and Lim
/
Comp Edit
/
Bypass
[
8
]
buttons
The UTILITY button allows the User to enter the Sub-menus and set the general characteristics of the
Processor. The EQ Edit/Mute buttons allow the User to enter the Editing Menus of the DS-CP25’s input
Channels EQ Section and Outputs Mute, and buttons Lim/Comp Edit/Bypass allow the User to enter the
Editing Menus of the DS-CP25's RMS Compressors, Output Limiter and Compressors Bypass.
The EQ Edit/Mute buttons as well as the Lim/Comp Edit/Bypass buttons have double functions dependent
on the push and hold time.
When the EQ Edit/Mute buttons are pushed and held for more than two seconds, Input Channels LIN or
RIN are either muted or unmuted. The red LED will illuminate when the Channel is muted.
When the “MUTE” LED is OFF, then the related Input Channel is UN-MUTED.
A momentary push of the EQ Edit/Mute buttons enters the Editing Mode for the DS-CP25’s Input Channels
Eq Section (see later for the Input Channel Editing details). The blue “EDIT” LED will now be ON.
When the Lim/Comp Edit/Bypass buttons are pushed and held for more than two seconds, the related
Compressor’s Output is either muted or unmuted. The red LED will illuminate when the selected
Compressor’s Output is MUTED. When the “MUTE” LED is OFF, then the related Compressor’s Output
Channel is UN-MUTED.
A momentary push of the Lim/Comp Edit/Bypass buttons enters the Editing Menu for the related
Compressor (see later for the Output Channel Editing details). The blue “EDIT” LED will now be ON.
• DS-CP25 Menu and Sub
-
Menu Structures
As stated above, the start-up default screen is the currently running preset or, if the device is new, the flat
“Preset 01” preset:
From this point, sub-menus are accessed using the “UTILITY”, “EQ Edit/Mute”, “Lim/Comp Edit/Bypass”,
“ENTER” and “ESC” buttons and all parameters and values are navigated by the “NAV/PM1”, “PM2” and
“PM3” encoders.
Multi-Band Compressor
Preset 01
5
