XYJGT80QFSDE-001
44
拆除线束
Remove Harness As
1.
用剪钳剪掉图一所示
扎带，然后拔掉发热管
上线束端子
2.
用十字批拆除图一所
示地线螺钉
3.
用十字批拆除图二所
示螺钉
4.
拆除图三所示铁扎线
（ 沿 电 机 线 束 共 有 三
处）
5.
拔掉电机接线端子、
地线端子，取出线束（如
图四所示）
1.Use diagonal cutters
to cut off the tie as
shown in figure 1,
then
pull out the wiring
harness terminals on
the heating tube
2.
Remove the ground
screw as shown in
figure 1 with a cross
screwdriver
3. Remove the screw
as shown in figure 2
with a cross
screwdriver
4.
Remove the iron tie
wire as shown in
Figure 3 (there are
three places along the
motor wiring harness)
5.
Unplug the motor
terminal and ground
terminal and take out
the harness as (as
shown in Figure 4).
1.
使用剪钳时注意不要
剪到线组
1.Pay attention not to
cut the thread group
when using the
diagonal cutters.
图二
fig.2
图四
fig.4
使用工具
using tools
剪钳
diagonalc
utters
十字批
cross
screwdriver
图一
fig.1
扎带
ties
地线螺钉
The ground screw
图三
fig.3
电机
Motor
r
