English
18
8 Place a large container (1.5 l) under the coffee and milk dispensing
spouts.
9 Press the OK button to start the descaling cycle.The machine dispenses
the entire descaling solution at regular intervals through the coffee and milk
dispensing spouts (this takes approximately 25 minutes).
10 Wait until all of the descaling solution has been dispensed. Remove and
empty the container and the milk carafe.
11 Remove and empty the drip tray. Slide the drip tray back into the
machine.
12 Rinse the water tank and fill it with fresh water up to the CALC CLEAN
indication. Slide the water tank back into the machine.
13 Fill the milk carafe with fresh water up to the MIN level and place it back
into the machine. Place the container back under both spouts.
14 Press the OK button to start the rinsing cycle (this takes approximately 4
minutes).
The display shows the following icon to indicate that the rinsing cycle is
finished.
15 Rinse the water tank and place the water filter back into the water tank
(if it was installed).
16 Fill the water tank with fresh water up to the MAX level. Slide the water
tank back into the machine.
17 Press the OK button to end the descaling cycle.
18 Place a container under the coffee and milk dispensing spouts.
19 The display shows the following icon to indicate that the machine is
heating up.The machine performs an automatic rinsing cycle.
20 Remove and clean the milk carafe see chapter ‘Cleaning and
maintenance’, section ‘Weekly cleaning of the milk carafe’. Insert the water
dispensing spout into the machine.
21 Remove and empty the drip tray. Slide the drip tray back into the
machine.
22 Remove and rinse the brew group see chapter ‘Cleaning and
maintenance’, section ‘Clean the brew group’.The machine is now ready for
use.
Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very
end without turning off the machine. In case you get stuck during the cycle
or in case of power failure or accidental disconnection of the power cord,
you can exit by pressing the standby button. If this occurs, empty and rinse
carefully the water tank, then fill it up to the CALC CLEAN level. Follow
the instructions in chapter ‘First installation’, section ‘Manual rinsing cycle’
before brewing any beverage. If the cycle was not completed, the machine
will require another descaling cycle to be performed at your earliest
convenience.
CALC
CLEAN
