9
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
8
▯
Do not repair or replace any part
of the appliance or attempt any
service unless specifically
recommended in the user
maintenance instructions or
Gaggenau® published user-repair
instructions that you understand
and have the skills to carry out.
▯
Always unplug the washing
machine from the power supply
before attempting any service.
Disconnect the power cord by
grasping the plug, not the cord.
▯
Do not machine wash fiberglass
materials (such as curtains and
window coverings that use
fiberglass materials). Small
particles may remain in the
washing machine and stick to
fabrics in subsequent wash loads
causing skin irritation.
▯
Do not install or store the washer
where it will be exposed to the
weather. Hoses and internal parts
may be damaged if exposed to
freezing temperatures.
▯
Do not use the washing machine if
it has a worn power cord or loose
plug.
▯
The washing machine must only
be used for its intended purpose.
▯
Always follow the fabric care
instructions recommended by the
clothing manufacturer.
▯
Make sure all water connections to
the washing machine have shut-off
valves that are readily accessible
during normal operation of the
washer. Turn off both valves
during periods in which the
washer is not in use and before
leaving for extended periods such
as vacations to reduce the risk of
water damage in the event of a
leak. Turn the valves back on prior
to resuming use of the washer.
▯
Do not operate the washing
machine if parts are missing or
broken.
▯
Do not operate the washing
machine until you are sure that:
– the washing machine has been
installed according to the
Installation Instructions.
– all water, drain, power and
grounding connections are in
compliance with all local
regulations and/or other applicable
regulations and requirements.
▯
Certain internal parts are
intentionally not grounded and
may present a risk of electric
shock during servicing. Service
Personnel – DO NOT CONTACT
the following parts while the
appliance is energized: inlet
valves, drain pump, heat sink of
the motor controller, PCBs.
▯
See the installation instructions in
this manual for grounding
requirements.
