Installing the control panel
• Before installation, remove all styrofoam
packaging from the control knobs and peel off
the protective film behind the luminous discs.
• Open the lid of the connecting terminal on the
control panel. Secure the mains connecting lead
as shown in the connection diagram. Secure the
connecting lead with the pull relief. The mains
connecting cable must at least correspond to the
type H 05 VV-F (3 x 1.5 mm
2
). Close the lid of the
connecting terminal.
• Hold the support plate from the rear against the
cabinet front, insert control knobs into the holes,
secure from the rear with the nuts.
Take care to install control knobs in the correct
order: left control knob for mode selection, right
control knob for temperature selection.
• Secure the control panel with the included nuts
onto the support plate.
16
Note:
only install control panel with appliance of the
corresponding type.
Before connecting the appliance, make sure
the electricity is switched off at fuse point!
