25
Fault, what to do?
Refill indicator for salt
`
and/or
rinse-aid
h
is not lit.
Refill indicator switched off.
Activation/deactivation (see chapter Water sof-
tening system/Special salt or Rinse aid).
There is still enough special salt/rinse
aid available.
Check refill indicator, levels.
Water is left in the appliance at
the end of the programme.
Filter system or area under the filters
1Z
is blocked.
Clean filters and area underneath (see “Waste
water pump”).
Program has not ended yet.
Wait until programme ends or reset (see “Ter-
minating the programme”).
Utensils not dry.
No or too little rinse aid in the dis-
penser.
Refill rinse aid.
Programme selected without drying.
Select programme with drying (see “Overview
of programmes”, “Programme sequence”).
Water collecting in depressions on the
utensils and cutlery.
Arrange utensils in a sloping position, arrange
affected utensils as sloping as possible.
The combined detergent used has a
poor drying performance
Use different combination detergent with bet-
ter drying performance. Use of rinse aid also
increases the drying performance.
Intensive drying to increase drying not
activated.
Activate intensive drying (see “Operating the
appliance”)
Utensils were removed too early or dry-
ing process had not ended yet.
Wait until program ends or wait until 30 min
after program ends before removing utensils.
The eco rinse aid used has a poor dry-
ing performance.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic utensils not dry.
Special properties of plastic.
Plastic has a lower heat storage capacity and
therefore dries less well.
Cutlery not dry.
Cutlery not arranged properly in the
cutlery basket.
Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly in the
cutlery drawer.
Arrange cutlery properly and separate if possi-
ble.
Appliance interior wet after rinse
cycle.
No appliance fault
On account of the “Condensation drying” prin-
ciple, water droplets are physically induced
and required in the container. The humidity in
the air condenses on the inner walls of the
dishwasher, drains and is pumped out.
Fault
Cause
Remedial action
