24
Fault, what to do?
Fault table
Fault
Cause
Remedial action
“Check water supply” display
X
lights up.
Supply hose kinked.
Install supply hose without kinks.
Tap turned off.
Turn the tap on.
Tap jammed or calcified.
Turn the tap on.
Flow rate must be min. 10 l/min. when water
supply is open.
Filter in the water supply blocked.
Switch off the appliance and pull out the mains
plug. Turn off the tap. Unscrew water connec-
tion.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks. Recon-
nect power supply. Switch on the appliance.
Error code
“
:
‹ˆ
is lit.
Intake opening (on right inside of appli-
ance) covered by utensils.
Arrange utensils so that the intake opening is
not obstructed.
Error code
“
:
‚ƒ
is lit.
Heating element calcified or soiled.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the set-
ting (see chapter “Water softening system/
Special salt”).
Fault code
“
:
‚…
is lit.
Water protection system activated.
Turn off tap.
Call customer service and mention the fault
code.
Fault code
“
:
‚†
is lit.
Fault code
“
:
‚‡
is lit.
Constant water inflow.
Error code
“
:
ƒƒ
is lit.
Filters
1Z
are soiled or blocked.
Clean filters.
(see “Cleaning and maintenance”).
Error code
“
:
ƒ…
is lit.
Waste-water hose kinked or blocked.
Install hose without kinks, remove any residue.
Siphon connection still sealed.
Check connection to siphon and open if
required.
Cover on the waste water pump loose. Lock cover correctly.
(See “Waste water pump”)
Error code
“
:
Ġ
is lit.
Waste water pump blocked or cover on
the waste water pump is not locked in
position.
Clean pump and lock cover correctly. (See
“Waste water pump”)
Error code
“
:
ƒˆ
is lit.
Mains voltage too low.
Not an appliance fault, have the mains voltage
and electrical installation checked.
A different error code is indicated
on the digital display.
(
“
:
‹‚
to
“
:
„‹
)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF switch
(
. After a short time restart the appliance.
If the problem recurs, turn off the tap and pull
out the mains plug.
Call customer service and mention the error
code.
Display flashes.
Door not closed properly.
Close the door. Ensure that no objects (uten-
sil, fragrance dispenser) are protruding over
the basket and preventing the door from clos-
ing.
Refill indicator for salt
`
and/or
rinse-aid
h
is lit.
No rinse aid.
Refill rinse aid.
No salt.
Refill with special salt.
Sensor does not detect salt tablets.
Use different special salt.
