Gaggenau BSP2201.1, User Manual And Installation Instructions

Page: 41 / 48

Installation instructions
en
41
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡
Switch off the power supply before carrying
out any work.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Do not use the door handle for transport or
installation.
¡
When installing, observe the current, valid
building regulations as well as the regional
power company's regulations.
¡
Install the appliance in accordance with the
installation diagram. Observe the minimum
clearances.
¡
Installation behind cabinet doors: Suitable
measures should be taken to ensure these
types of doors cannot close during opera-
tion. There is a risk of overheating if the
door does not remain open during opera-
tion or during cooling (fan operation).
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
The dimensions in the figures are in mm.
18.2 Planning notes
Observe the following planning notes before installing
the appliance.
¡
The door direction cannot be reversed.
¡
The distance from the cabinet cavity to the door
panel surface is 21 mm.
¡
The distance from the cabinet cavity to the outer
edge of the door handle is 72 mm.
¡
Note the front projection, including the door handle,
for opening drawers next to the appliance.
¡
When planning a corner solution, consider a door
opening angle of at least 110°.
¡
Do not install any other electrical appliance in the
cupboard above this appliance.
¡
This appliance is intended for front flush installation.
Even with a minor protrusion of the cabinet panel
above the appliance, there is a risk of damage to
the cabinet by escaping steam.
18.3 Appliance dimensions
You will find the dimensions of the appliance here
18.4 Preparing the units
Requirement:
Fitted units must be heat-resistant up to
90 °C, and adjacent unit fronts up to 70 °C.
1.
Ensure that the mains socket is located outside of
the built-in niche.
2.
Carry out cut-out work on the units and then insert
the appliance.
3.
After making the cut-outs, remove any shavings.
Shavings may impair the function of electrical com-
ponents.
4.
Secure any unsecured units to the wall using a
standard bracket.
5.
Only install the appliance high enough that the cus-
tomer can remove the accessory effortlessly.
18.5 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡
The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡
The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to the local regulations.
¡
The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡
The appliance must only be connected using the
power cable provided. Plug the power cable fully
into the back of the appliance.
¡
The power cable must only be replaced with a cable
from the original manufacturer. The power cable can
be obtained from customer service.
¡
Contact protection must be guaranteed by the in-
stallation.
Power cable with a plug with earthing contact
For an appliance with a plug with earthing contact, fol-
low these instructions.
¡
Connect the appliance only to a correctly installed,
earthed socket.
¡
If the plug with earthing contact can no longer be
accessed after installation, an energy-isolating
device in the phases must be provided in the per-
manent electrical installation in accordance with the
installation regulations.